1. Summary of this guide
This guide provides the information needed to configure, use, and update the WizFi630S on the
WizFi630S-EVB. It is intended for software developers and system integrators who are embedding this
product into their designs.
1.1 Included chapters
Product overview: Main features of the WizFi630S and an Evaluation broad
◼
Operation mode
◼
Configuration methods: Instruction for accessing methods, Web manager and CLI
◼
Network setting: Instruction for configuring network using Web Manager and CLI method
◼
System setting: Introduction for adding new software and updating new firmware
◼
2. Product overview
WizFi630S is a gateway module that include the UART protocol and TCP/IP protocol into
IEEE802.11 b/g/n wireless LAN protocol. WizFi630S enables a device with serial interface to
connect to LAN or WLAN for remotely control, measuring, and administration. WizFi630S can also work
as an IP router because of its internally embedded switch.
WizFi630S uses interfaces like Serial(UART), LAN, Wi-Fi(WLAN) to perform functions such as
Serial(UART)-To-Wi-Fi, Serial-To-Ethernet, Ethernet-To-Wi-Fi. Users can connect to WizFi630S's internal
web server or use serial commands for simple Wi-Fi settings; not only serial devices but 8/16/32 bit
micro controllers can also use UART for simple Wi-Fi settings.
WizFi630S can significantly reduce the processes for wireless module design, testing, and certification.
Therefore, WizFi630S can be the best solution for users who lack wireless network experience.
WizFi630S follows the 802.11b/g/n standard and support up to 150Mbps speed in wireless interface.
WizFi630S provides a test board, pc software, and documents so that anyone can develop a wireless
solution.
© Copyright 2019 WIZnet Co., Ltd. All rights reserved.
WizFi630S Manual
5