2.2 Configuration Tool
2.2.1 Network Configuration
ⓐ Version : Displays firmware version.
ⓑ Enable Serial Debug Mode : If this mode is checked, you can monitor the status and
socket message of WIZ110SR (listen OK, connect fail etc.) through serial terminal. If Debug
mode is on, debug message can cause abnormal operation of the serial device. Therefore,
just use this mode only for Debug mode.
ⓒ Board List : If you click "Search" button, all the MAC addresses on a same subnet, will be
displayed.
Copyright © WIZnet All Rights Reserved
ⓐ
ⓑ
ⓒ
ⓘ
ⓙ
Figure 2. Configuration Tool (Network Config)
ⓓ
ⓔ
ⓕ
ⓖ
ⓗ
ⓛ
ⓜ
ⓚ
ⓝ
ⓞ
ⓟ
ASRB for SERIAL | 9 page