Troubleshooting - Duramaxx Angkor Manual

Problem
No power,no boot
sound.
Sound a successive
"DU" "DU" tone.
Sound an irregular
tone,or the target
identification cursor
chatters.
There is water going
into the battery box.
22

Troubleshooting

Possible Cause and Solution
Be sure that the batteries are installed correctly.
Replace the batteries.
Make sure that there is no other metal detector operating
around.
Low battery, replace the batteries.
Don't use it indoors,because there is many metals there.
Make sure whether there is electromagnetic interference sources,
such as power lines,cables,electronic fences and so on. Keep
away from these areas,or try to reduce the sensitivity.
Search in another place,in order to determine whether you can
get a more stable signal.
If the target is buried deeply,you could try to increase the
sensitivity or speed up the speed of sweeping the search coil,in
orde to get a more stable signal. Maybe more than one metal
targets buried there.
Maybe you find a severe oxidation target,or the ground is serious
magnetic,you should try to decrease the sensitivity.
The battery cover is too loose.
Adding a few silicon grease on the rubber gasket or replaced the
attached rubber gasket.