Care And Maintenance - Duramaxx Angkor Manual

Hide thumbs Also See for Angkor:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 13
4. Move the search coil: When detecting,you should move the search coil at a constant
speed, not unsteadily. Let the search coil be parallel with and about 1/2 inch from the
surface, not to swing it like a pendulum high and low above the ground.
Wrong
Most valuable metal objects will send repeatable signals. If the signal isn't repeatable,it's mostly a
false signal.You can also move the search coil quickly,and observe whether can get stable signal.
When there is a clear sound instructing the buried targets,you could differentiate the metal cate-
gory roughly with the aid of DISC knob. Please note this kind of judgment is only as a reference.
When doing the decision whether to dig or not,be careful not to have the treasures omitted.
Caution
In areas with heavy traffic, please not wear earphone,in case an accident occurs.
Keep away from the region where may bury electrical line,cable line or pipeline,in parti-
cular the pipes that are full of flammable gases and liquids.Do no detect in the military
area where may bury bombs or gas explosives.
When excavating the target,use the reasonable method, don't destroy the vegetation.
Leave the land and vegetation as it was after the excavation.Take out the targets in the
water,you can use sand scoop.
If in the detection area,there are two detectors at the same time,and they are quite
close to each other, it will cause problem to each other.In this case,you should reduce
the sensitivity or keep two detectors more than 10 meters away from each other
The metal detector is a specially designed waterproof detector.The following suggestions
will help you to maintain the metal detector,so that you can use it for a long time.
Don't open the front and back cover of the control box.The control box adopts the
special waterproof measures.It would seriously affect its waterproof function,without
special tools to open it.
Don't open the headphones easily.The headphone waterproof measures is installed in
the buzzer.After using in the water,it is normal that there is water in the headset box,it
will not affect the waterproof performance.As long as hold up the headphone,let the
water be out.
Don't cut the cable wrapping,otherwise,it will affect the waterproof performance.
After using on the beach,you can rinse it by clean water,and dry it with a dry towel.Don't
use hand sanitizer and detergent to clean the detector.
When don't use it, store it in a dry room.

Care and Maintenance

Right
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kt-angkor10029917

Table of Contents