Quick Start - Duramaxx Angkor Manual

LED and Earphone
When detecting a target,the LED will flash of white light,at the same time,the earphone
will sound a beep tone.The closer from the target,the more powerful the LED flashing,the
louder the beep tone being.When the battery needs to be replaced,the LED will flash
continuously,and sound a short "dudu"tone.
1. Prepare with the three metal samplesr: an iron nail, a pull-tab a silver coin.
2. Place the detector on a wooden or plastic table,let the search coil exceeds the table edge
about more than 30cm.keep the detector away from the wall,ceiling and floor,turn off all
the equipment which can cause electromagnetic interference.Please take off the watch,
ring or other metal objects on your hand.
3. Rotate the "SENS" knob clockwise to turn on the unit,the LED will flash of white light
once,and the buzzer will sound "dudu"tone.Set the "SENS"knob to the middle position.
4. Test the ALL METAL mode. Set the
"DISC" to the position of A-M.Sweep
the three metal samples 8 to 10cm
above the search coil respectively,
(note that the samples should be
swept out of the search coil edge).
The unit will be respond to all the
metals,and the LED will flash of white
light,the buzzer will sound tone.It me-
ans the detector has effect on all kinds
of metals
18

Quick Start