ICP DAS USA ISaGRAF mPAC Series Getting Started page 7

Communication Interface
COM1
COM2
Ethernet
LED Indicator
Programmable LED
Hardware Expansion
I/O Expansion Bus
Dimensions
W x H x D
PWM Output
Pulse Width
Modulation Output
Counters
Parallel DI Counter
Remote DI Counter
Remote High Speed
Counter
Protocols
Modbus RTU/ASCII
Master Protocol
Modbus RTU Slave
Protocol
Modbus TCP/IP Slave
Protocol
Remote I/O
Fbus
Getting Started: PAC-5007(P)/5107(P)/5207/5307 Ver. 1.0, 07/2010
RS-232: TxD, RxD, RTS, CTS, GND, Non-Isolated.
Baudrate: Max. 115200 bps, Program downloads port.
RS-485: D2+, D2-, Non-Isolated, self-tuner ASIC inside.
Baudrate: Max. 115200 bps.
RJ-45 x 1, 10/100 Base-TX, Program downloads port.
(Auto-negotiating, Auto MDI/MDI-X, LED indicator)
2 (for User-Defined)
Yes (for one XW-board).
91 mm x 123 mm x 52 mm
All XW-Board series DO boards support PWM output. Max. 8 channels for
one controller. 500 Hz max. for Off=1 & On=1 ms
Output square curve: Off: 1 ~ 32767 ms, On: 1 ~ 32767 ms
All XW-Board series DI boards support DI counter. Max. 8 channels for one
controller.
Counter value: 32 bit; 500 Hz max. Min. ON & OFF width must > 1 ms
All remote I-7000 & I-87K DI modules support counters. 100 Hz max.
value: 0 ~ 65535
Optional I-87082: 100 kHz max. , 32 bit
Up to 2 COM Ports (COM1, COM2 and COM3-in-XW-Board) support
Modbus RTU/ASCII Master protocol to connect to other Modbus Slave I/O
devices. Max. Mbus_xxx Function Block amount: 128.
Up to 2 COM Ports (COM1 and one of COM2/COM3-in-XW-Board) can
support Modbus RTU Slave protocol for connecting ISaGRAF, PC/HMI/OPC
Server & MMI panels.
Ethernet port supports Modbus TCP/IP Slave protocol for connecting
ISaGRAF & PC/HMI. Max. 6 connections.
One of COM2 or (COM3:RS-485 in-XW-Board) supports I-7K, I-87K I/O
modules as Remote I/O. I-87K series must plug on RU-87P(High profile) or
I-87K(Low profile) I/O Unit. Max. 64 I/O modules for one PAC.
Built-in COM2 Port to exchange data between ICP DAS's ISaGRAF PACs.
. 7
ICP DAS