3. Now, you can set the Address, Baud rate and Checksum. After configuration, you
must click "Setting" to save the settings.
4. You have completed the setting; please adjust the DIP Switch to "OFF" position and
restart the power. Finally, you can serch the module again to comfirm settings.
Follow the steps to
comfirm the settings.
Note:
Remember to remove the wire between INIT* and GND, then restart the power if you
use the I-7000 I/O module.
Getting Started: PAC-5007(P)/5107(P)/5207/5307 Ver. 1.0, 07/2010
3-20
3.
ICP DAS