Using The Equalizer Lock Function - Yamaha Clavinova CVP-105 Owner's Manual

Adjusting the Timbre
C Select the band to be adjusted.
Select the band you wish to adjust by pressing the BAND < or >
buttons.
The central frequency of the selected band (expressed in Hz) is
displayed by the BAND function.
V Change the gain value.
Change the value of the gain either by pressing the GAIN
buttons, or by using the data dial or [–] and [+] buttons.
The new value is shown in the GAIN section of the display.
Since the value can be changed during playback, you can adjust the
settings while listening to the changes in the sound.
When you change a gain value, an asterisk (*) will appear near the
name of the selected equalizer setup to indicate that the settings have
been changed. By default, these settings will not be retained when the
power is turned off. If you want the Clavinova to retain your settings
while the power is off, you can turn on the BACKUP function for the
VOICE SETTING parameter group (page 206).

Using the Equalizer Lock Function

When equalizer setting values are contained in the song data, or when the
equalizer setting data is received via MIDI, the current settings in the MAS-
TER EQUALIZER display will be overridden by the settings of the song
data or MIDI data. Set EQ LOCK to ON to prevent reception of this data, or
OFF to enable reception.
26
CVP-109/107/105/700
(CVP-109/107/700)
........................................................
...............................................................................
Gain
and
• Settings: –12 — 0 — +12 (dB)
• Basic setting: varies depending on
equalizer setup and band.
• Backup of last settings: OFF
• Distortion could result if the gain is set
to higher levels. If this happens, re-
duce the overall volume with the [MAS-
TER VOLUME] control.
EQ LOCK
• Settings: ON, OFF
• Basic setting: OFF