Yamaha Clavinova CVP-105 Owner's Manual page 217

Connecting to an Apple Macintosh or Compatible Com-
puter
................................................................................................................................................
Connect the [TO HOST] connector of the Clavinova to the modem or printer
port on your Macintosh (whichever port your MIDI software is using for MIDI
data communication) using a standard Macintosh 8-pin system peripheral cable.
Set the [HOST SELECT] switch to the "Mac" position.
You may also have to make other MIDI interface settings on the computer
side, depending on the type of software you use (refer to your software owner's
manual). In any case, the clock speed should be set to 1 MHz.
Set to the "Mac"
position.
Mac MIDI
PC-1 PC-2
TO HOST HOST SELECT
Apple Macintosh
compatible computer
Connecting to an IBM-PC/AT Series Computer
Connect the [TO HOST] connector of the Clavinova to the RS-232C port on
your IBM computer, using a standard 8-pin MINI DIN
cable. Set the [HOST SELECT] switch to the "PC-2" position.
Refer to your software owner's manual for information on any settings you
might have to make on the computer side.
Set to the "PC-2"
position.
Mac MIDI
PC-1 PC-2
TO HOST HOST SELECT
IBM-PC/AT compatible
computer
Connector Pin Numbers
MINI DIN 8-PIN
6 7 8
3 4 5
1 2
D-SUB 9-PIN
5 4 3 2 1
9 8 7 6
"Mac" Cable Connections
1
MINI DIN
2
8-PIN
3
4
5
6
7
8
• 8-pin system peripheral cable
• Data transfer rate: 31,250 bps
"PC-2" Cable Connections
MINI DIN
8-PIN 1
2
3
4
8
5
• 8-pin mini DIN 9-pin D-SUB cable
• Data transfer rate: 38,400 bps
MIDI Driver
The Music Software Collection disk that came with your Clavinova
contains special MIDI driver software intended for use with the Win-
dows 95 and Windows 98 operating systems. This driver software may
be necessary when using computer software with the Clavinova. Install
the MIDI driver from the disk to your computer if necessary. Refer to
the text files on the disks (listed below) for installation instructions.
2 (HSK i)
MINI DIN
1 (HSK 0)
8-PIN
5 (RxD-)
4 GND
3 (TxD-)
8 (RxD+)
7 (GP i)
6 (TxD+)
................................
9-pin D-SUB cross
8 (CTS)
D-SUB
7 (RST)
9-PIN
2 (RxD)
5 (GND)
3 (TxD)
A:\driver\readme_e.txt
A:\driver\licensee.txt
"A:" is the name of the floppy disk drive.
Data Connections
If your system doesn't work
properly with the connections
and settings listed above, your
software may require different
settings. Check your software
operation manual: if it requires
a 31,250 bps data transfer rate,
set the [HOST SELECT] switch
to "PC-1."
CVP-109/107/105/700
217