Yamaha 007POTO-G0 Owner's Manual page 147

If you've selected DEFINE in the SOURCE SELECT
field, you can use the ASSIGN field to select multiple
sources. The following table shows the monitor
sources you can select in the ASSIGN field.
MIX 1–16 buttons MIX channels 1–16 output signals
MATRIX 1–8 but-
MATRIX buses 1–8 output signals
tons
STEREO L/R button STEREO L/R channel output signal
MONO button MONO channel output signal
2TR L/R button 2TR IN DIGITAL jack input signal
INPUT 15/16 {31/32} INPUT channels 15/16 {31/32} input
button signal
PLAYBACK OUT
USB memory recorder playback signal
button
NOTE
• You can select a maximum of eight monitor sources in the
ASSIGN field. If you select eight monitor sources, no further
selections will be possible. Please turn off the buttons for
unneeded sources.
4
Move the cursor to one of the port select
boxes (L/R/C) located below the level meter,
and press the [ENTER] key.
The OUT PORT SELECT popup window will appear,
allowing you to specify the port from which the L, R,
and C monitor signals will be output.
5
Move the cursor to the output destination
port and press the [ENTER] key to select it;
then move the cursor to the CLOSE button
and press the [ENTER] key to close the
popup window.
The following table lists the output ports you can
select.
OMNI 1–8 {1–16} OMNI OUT jacks 1–8 {1–16}
2TR OUT L/R 2TR OUT DIGITAL jack L, R
Output channels 1–16 of an I/O card
SLOT {1/2} 1–16
installed in a slot {1/2}
HINT
• If desired, you can specify output ports only for MONITOR
OUT L and R, and monitor through two speakers. If you have
not specified an output port for MONITOR OUT C, selecting
the MONO button or LCR button as the monitor source will
automatically cause the MONO channel signal to be distrib-
uted to MONITOR OUT L/R.
6
To output the monitor signal, move the cur-
sor to the OUTPUT button of the MONITOR
screen and press the [ENTER] key to turn it
on.
The monitor source you selected in step 3 will be sent
to the output destination you specified in step 5.
HINT
• The PHONES OUT jack will always output the monitor signal,
regardless of whether the OUTPUT button is on or off.
7
Move the cursor to the MONITOR LEVEL
knob in the MONITOR screen, and use the
dial or the [DEC]/[INC] keys to adjust the
monitor level.
If PHONES LEVEL LINK is ON, you can use both
the MONITOR LEVEL knob and the front panel
PHONES LEVEL control to adjust the monitor level
when monitoring through headphones.
HINT
• If PHONES LEVEL LINK is on, the MONITOR LEVEL knob
will also affect the PHONES OUT jack.
• If you turn on MONITOR ON MASTER FADER that you've
assigned to a user-defined key, you'll be able to use the mas-
ter fader to control the monitor.
8
Make settings for Dimmer and Monaural as
desired.
HINT
• Monitor on/off operations, selection of the monitor source,
and dimmer on/off operations can also be assigned to user-
defined keys ( → p. 196).
LS9-16
Using the Monitor function
LS9-16/32 Owner's Manual
14
147