Yamaha 007POTO-G0 Owner's Manual page 61

L C R
TO ST PAN knob
If a ST IN channel is selected, operating the TO ST
BALANCE knob will change the signal levels sent
from the ST IN L/R channels to the STEREO (L/R)
bus and MONO (C) bus as shown in the following
illustration. In this case, the [PAN] encoder will oper-
ate as a conventional BALANCE knob, and no signal
is sent to the MONO (C) bus.
L C R
TO ST BALANCE knob
L C R
TO ST BALANCE knob
If the CSR knob is set to 100%, operating the TO ST
PAN knob will change the signal levels sent to the
STEREO (L/R) bus and MONO (C) bus as shown in
the following illustration.
L C R
PAN knob
Sending the signal from an input channel to the STEREO/MONO bus
If a ST IN channel is selected, operating the TO ST
BALANCE knob will change the signal levels sent
from the ST IN L/R channels to the STEREO (L/R)
Signal sent to the
bus and MONO (C) bus as shown in the following
STEREO (L) bus
illustration.
Signal sent to the
STEREO (R) bus
L
Signal sent from the
ST IN (L) channel to
the STEREO (L) bus
L
15
If you want to operate a channel that is not
currently shown in the popup window, use
the [SEL] key to select that channel, and
then make settings for it.
For example if INPUT channels 1–8 are shown in the
Signal sent from the
ST IN (R) channel to
popup window, pressing the INPUT channel 9 [SEL]
the STEREO (R) bus
key will change the popup window to INPUT channels
9–16.
16
When you've finished making settings,
move the cursor to the CLOSE button (or
the × symbol in the upper right of the win-
dow) and press the [ENTER] key.
Signal sent to the
MONO (C) bus
Signal sent to the
STEREO (L) bus
Signal sent to the
STEREO (R) bus
C R
TO ST BALANCE knob
C R
TO ST BALANCE knob
LS9-16/32 Owner's Manual
Signal sent from the
ST IN (L) channel to
the STEREO (L) bus
Signal sent from the
ST IN (L) channel to
5
the MONO (C) bus
Signal sent from the
ST IN (R) channel to
the STEREO (R) bus
Signal sent from the
ST IN (R) channel to
the MONO (C) bus
61