Yamaha 007POTO-G0 Owner's Manual page 107

B Channel select buttons
Select the channels that will be assigned to the USB
memory recorder's inputs, from the following choices.
●
MIX 1–16
MIX channels 1–16
●
MTRX 1–8
MATRIX channels 1–8
●
ST L/R
STEREO channel L/R
●
ST L+C
STEREO channel L mixed with the MONO (C)
channel
●
ST R+C
STEREO channel R mixed with the MONO (C)
channel
●
MONO
MONO channel
●
CH1–32 {1–64}
Direct output of an INPUT channel 1–32 {1–64}
3
Use the category tabs and the port select
buttons to select the channel that you want
to patch to the USB memory recorder input.
If you select a channel to which another port is already
patched, a dialog box will ask you to confirm the patch
change. Move the cursor to the OK button of the
dialog box and press the [ENTER] key.
NOTE
• You cannot assign multiple channels to a single input.
4
When you've finished making the assign-
ment, move the cursor to the CLOSE button
and press the [ENTER] key.
You will return to the RECORDER screen.
5
Assign a channel to the other input in the
same way.
HINT
• The USB memory recorder always records and plays back in
stereo. If you want to record in monaural, with the same signal
for left and right, you must assign both of the recorder inputs
to the same channel.
Assigning channels to the input/output of the recorder
6
To assign channels to the recorder outputs,
move the cursor to the PLAYBACK OUT
popup button L or R, and press the
[ENTER] key.
The OUTPUT CH SELECT popup window will
appear.
1
2
1 Category tabs
These tabs select the type of channels shown in the
lower part of the window.
●
CH 1-32 {1-32/33-64}
INPUT channels 1–32 {1–32/33–64} will be
shown
●
ST IN
L/R channels of ST IN channels 1–4 will be
shown.
B Channel select buttons
Select the channels that will be patched to the USB
memory recorder's outputs, from the following
choices.
●
CH 1–32 {1–64}
INPUT channels 1–32 {1–64}
●
STIN 1L/1R–STIN 4L/4R
L/R channels of ST IN channels 1–4
7
Use the category tabs and the channel
select buttons to select the channel that
you want to patch to the USB memory
recorder input.
If you select a channel to which another signal is
already patched, a dialog box will ask you to confirm
the patch change. Move the cursor to the OK button of
the dialog box and press the [ENTER] key.
HINT
• You can patch multiple channels to the recorder output.
8
When you've finished making the assign-
ment, move the cursor to the CLOSE button
and press the [ENTER] key.
You will return to the RECORDER screen.
9
Assign a channel to the other output in the
same way.
LS9-16/32 Owner's Manual
LS9-32
10
107