Yamaha 007POTO-G0 Owner's Manual page 119

6
Select the key-in signal as necessary.
You can select one of the following as the key-in sig-
nal.
For an input channel
The signal immediately before the
SELF PRE EQ EQ (attenuator) of the currently
selected input channel
The signal immediately after the EQ
SELF POST EQ of the currently selected input chan-
nel
CH 1–32 {64} POST The signal immediately after the EQ
EQ, STIN1L/1R–4L/4R of the corresponding input channel
POST EQ
(*1)
The signal immediately after the ON
MIX OUT 13–16
of the corresponding MIX channel
*1: The signals that you can select are limited to the group to which
that channel belongs, from the following five {nine} groups: CH
1–8, CH 9–16, CH17–24, CH25–32, {CH33–40, CH41–48,
CH49–56, CH57–64}, and STIN1L1R–4L4R.
For an output channel
The signal immediately before the
SELF PRE EQ EQ (attenuator) of the currently
selected output channel
The signal immediately after the EQ
SELF POST EQ of the currently selected output chan-
nel
MIX 1–16 POST EQ,
The signal immediately after the EQ
MTRX1–8 POST EQ,
of the corresponding output channel
ST L/R, MONO, POST
(*1)
EQ
The signal immediately after the ON
MIX OUT 13–16
of the corresponding MIX channel
*1: The signals that you can select are limited to the group to which
that channel belongs, from the following four groups: MIX 1–8,
MIX 9–16, MATRIX 1–8, and ST/MONO.
HINT
• If the dynamics type of DE-ESSER, the key-in signal is fixed
at SELF POST EQ and cannot be changed.
To select the key-in signal, make your selection in the
DYNAMICS 1/DYNAMICS 2 popup window.
1 Move the cursor to the KEY IN SOURCE box,
and use the dial or the [DEC]/[INC] keys to
select the desired key-in signal.
The newly selected key-in signal will blink.
B Press the [ENTER] key to confirm your selec-
tion of key-in signal.
NOTE
• If you move the cursor out of the KEY IN SOURCE box while
the key-in signal is blinking in the box, your change will be dis-
carded, and the key-in signal setting will revert to the previous
choice. To confirm your new choice of key-in signal, press the
[ENTER] key without moving the cursor.
7
If you want to initialize dynamics settings or
copy them to another channel, use the tool
buttons in the DYNAMICS 1/DYNAMICS 2
popup window.
For details on how to use these buttons, refer to "Using
the tool buttons" (→ p. 35).
HINT
• You can also use a dedicated library to save or load dynamics
settings at any time ( → p. 120). You can also take advantage
of a wide variety of presets suitable for various instruments or
situations.
LS9-16/32 Owner's Manual
Using dynamics
11
119