Table 8-5 Types Of Thermo Labels - Mitsubishi S16R Series Operation & Maintenance Manual

8 INSPECTION AND MAINTENANCE
■ Temperature control with thermo
label
On the damper, a thermo label is attached as a
guide.
When the thermo label reaches the specified
temperature, the white heat-sensitive area turns
black.
Control and Record the temperature regularly, and
check any abnormal temperature changes.
• Once the heat-sensitive area of the
thermo label turns its color, it will
never return to the original color again.
• A thermo label is attached as a guide. It
is recommended to measure the
temperature while operating the
engine with a noncontact thermometer
(thermo gun) and to control and record
it accordingly.
Make sure with a noncontact
1
thermometer (thermo gun, and
others) that the surface of the
engine is cooled down so that you
can touch.
Stick a thermo label (1) onto the
2
outer face of the damper.
• Avoid the stamped marking.
S16R
(1)
S16R2
(1)
Fig. 8-14 Thermo Label - Stick
140

Table 8-5 Types of Thermo Labels

Part name
Thermo label 100-120
Thermo label 75-95
Thermo label 50-70
Operate the engine at the rated load
3
for about an hour.
Operate the stop switch
4
and Stopping Devices Installed
during Manufacturing the Generator"
(→ Page 87)
off the engine.
Check the heat-sensitive area of the
5
thermo label and record the highest
temperature.
If a temperature rise is observed, locate the
defect in the engine or other causes. In
addition, replace the thermo label with a
new one and check the change of
temperature again.
• If the detected temperature comes
close to the limit temperature of the
damper, or if there is any abnormal
change in temperature, contact your
SME dealer
8).
• For the temperature limit of the
damper, refer to
Temperature of Damper" (→ Page
139).
Mitsubishi Diesel Engine S16R & S16R2 OPERATION & MAINTENANCE MANUAL
Measurable tempera-
ture range (°C)
100 to 120
75 to 95
50 to 70
"Starting
of the generator to turn
"CONTACT LIST" (→ Page
"Table8-4 Limit
Pub. No. K29001-00320 Revision: 1