Mitsubishi S16R Series Operation & Maintenance Manual page 123

Table 7-4 Scheduled Maintenance for Continuous Use Engine (2/3)
Inspection and Maintenance
Period
Service
Service hours
period
Every 2000
-
service hours
Every 4000
- service hours
* 1
Every 8000
- service hours
* 1
*1: Service intervals vary depending on the use conditions. For details, see the rating definition
Definition" (→ Page
Mitsubishi Diesel Engine S16R & S16R2 OPERATION & MAINTENANCE MANUAL
Pub. No. K29001-00320 Revision: 1
Service Items
• Fuel Pipe - Check
• Oil Pipe - Check
• Engine - Top Overhaul (Remove the cylinder head, and
inspect and service the combustion chambers.)
• Turbocharger - Check
• Damper - Check
• Starter - Check
• Unit Seal and Oil Seal of Water Pump - Replace
• Protection System - Check
• Resin Fan Inspection
(Blade Inspection/Cleaning, Bolt Looseness Check and
Tightening)
• LLC Concentration in Coolant - Check
• Engine - Major Overhaul (Disassemble the engine, and then
clean, check, and replace major parts.)
<At the major overhaul>
Parts to be replaced:
Inlet and exhaust valves, inlet and exhaust valve seat
O-rings, valve rotators, valve cotters, rocker arm
adjusting screws, valve push rods, bridge caps,
camshaft bushings, main bearings, cylinder liners,
main bearing cap bolts and washers, piston rings,
connecting rod bearings, damper, crankcase thrust
plates and consumable items (gaskets, oil seals, O-
rings, and others.)
120).
7 SCHEDULED MAINTENANCE
Reference
Page
152
163
174
(Contact your
SME dealer
174
139
177
8
(Contact your
SME dealer)
173
114
8
(Contact your
SME dealer)
"Rating
123