Troubleshooting - Mitsubishi S16R Series Operation & Maintenance Manual

■ Engine - Lift
When lifting up the engine, do not
allow the operators to stay under the
engine.
* Otherwise, if the wire breaks, the engine may
fall down, which could cause serious personal
injury.
The engine must be lifted only by an
operator who is qualified for a crane
and slinging works and also well
skilled.
* Otherwise, the engine may fall by an operation
error, which could cause serious personal injury
or damage to the devices.
To lift the engine, take the mass of the
engine and that of water remained in
the engine into account, and use wire
ropes, shackles, and slings which are
strong enough to support the weight.
* Otherwise, the engine may slip down, which
could cause serious personnel injury or damage
to the devices.
* Check the contract specifications for engine dry
mass.
Use sling/hoisting tools in accordance
with their instruction manual.
* Otherwise, the engine may slip down, which
could cause serious personnel injury or damage
to the devices.
Use the hangers of the engine only for
lifting the engine unit.
* If you use them when the engine is assembled
with the generator and additional devices, the
hanger may not be able to endure the mass and
may break. If the engine falls, serious personnel
injury or damage to the devices will occur.
Before lifting the engine, drain fuel,
engine oil and coolant.
* Otherwise, the hanger may not be able to
endure the mass and break. If the engine falls,
serious personnel injury or damage to the
devices may occur.
Lift the slings while keeping the angle
formed by the slings attached to the
hangers within 60°.
* If the angle is too large, excessive weight will be
imposed on the hanger, which could cause
damage to the hanger.
Mitsubishi Diesel Engine S16R & S16R2 OPERATION & MAINTENANCE MANUAL
Pub. No. K29001-00320 Revision: 1

TROUBLESHOOTING

■ Precautions on Troubleshooting
Before inspecting and maintaining the
engine, read this Operation &
Maintenance Manual thoroughly to
understand the construction and the
required work to service the
corresponding part. In addition,
conduct the work after fully studying
the procedure
* In case of conducting the work without studying
enough, an accident or damage due to wrong
installation, or deterioration in the exhaust gas
properties may occur.
Do not take actions for items
indicated as "Contact your SME
dealer" in the measure column in the
Scheduled Maintenance.
* Otherwise, serious accident, environmental
pollution or damage to the devices may occur.
Be sure to contact your SME dealer.
Do not disconnect the pipes
immediately after the engine is
stopped.
* Otherwise, you could get burned by hot engine
oil or coolant splashing out.
When lifting a part or tool, check its
weight and lift it slowly.
* If you lift it carelessly, you may hurt your back or
get injured by dropping the part.
Make sure that dripped oil, parts,
tools or other things are not left on the
floor around the engine. Always
maintain cleanliness and tidiness.
* Otherwise, a tumbling accident may occur.
* Wear proper personal protective equipment for
the work.
Make sure that the tools to be used
are not damaged.
* Using a damaged tool or a wrong-size tool may
cause personal injury or damage to the devices.
Check and calibrate measurement
equipment periodically.
* Using uncalibrated measurement equipment
may cause damage to the devices or
performance degradation of them.
1 SAFETY
53