Unit Nameplate
The unit nameplate is located on the left side of the left
hand control panel. A typical unit nameplate is
illustrated in the following figure and contains the
following information:
•
Unit model and size descriptor
•
Unit electrical requirements
•
Correct operating charge and refrigerant type
•
Unit test pressures and maximum operating
pressures
•
Unit literature
S S e e r r i i a a l l N N u u m m b b e e r r . . The unit serial number provides the
specific chiller identity. Always provide this serial
number when calling for service or during parts
identification.
S S e e r r v v i i c c e e M M o o d d e e l l N N u u m m b b e e r r . . The service model represents
the unit as built for service purposes. It identifies the
selections of variable unit features required when
ordering replacements parts or requesting service.
N N o o t t e e : : Unit-mounted starters are identified by a
separate number found on the starter.
P P r r o o d d u u c c t t D D e e s s c c r r i i p p t t i i o o n n B B l l o o c c k k . . The CenTraVac™ chiller
models are defined and built using the Product
Definition and Selection (PDS) system. This system
describes the product offerings using a product coding
block which is made up of feature categories and codes
that identify all characteristics of a unit.
8
Figure 1. Typical unit nameplate
CDHF-SVX01N-EN