Table of Contents
Advertisement
Nameplate Information
Nameplates
The Sintesis outdoor unit nameplates are applied to the
exterior of the Control Panel. A compressor nameplate is
located on each compressor. When the unit arrives,
compare all nameplate data with ordering, submittal, and
shipping information.
Outdoor Unit Nameplate
See figure below for a typical unit nameplate. The outdoor
unit nameplate provides the following information:
•
Unit model and size description.
•
Unit serial number.
•
Identifies unit electrical requirements.
•
Lists correct operating charges of R-134a and
refrigerant oil (Trane OIL00311).
•
Lists unit test pressures.
•
Identifies installation, operation and maintenance and
service data literature.
•
Lists drawing numbers for unit wiring diagrams.
Model Number Coding System
Model numbers are composed of numbers and letters that
represent features of the equipment. Shown below is a
sample of typical unit model number.
Figure 1.
Typical unit nameplate
6
An example of a typical unit model number (M/N) is:
RTAF 130E UA0V XUA2 N21X 1NXN CVSC AXXX XPAX
1XXX X
Each position, or group of positions, in the model number
is used to represent a feature. Unit model number digits
are selected and assigned in accordance with the
definitions as listed in Model Number Description chapter.
For example, position 08 of the unit model number above
contains the letter "E". An "E" in this position means that
the unit voltage is 460/60/3.
Compressor Nameplate
The compressor nameplate provides the following
information:
•
Compressor model number. See Model Number
Description chapter.
•
Compressor serial number. See Model Number
Description chapter.
•
Compressor electrical characteristics.
•
Utilization range.
•
Recommended refrigerant.
RTAF-SVX001K-EN
Advertisement
Table of Contents
