Pmod™(Pmod1) - Renesas RX Series User Manual

RSKRX231
5.6 Pmod™(PMOD1)
The RSK board are equipped with connectors for Digilent Pmod™ interface. Please connect the PMOD1
connector that is compatible with Debug LCD.
Care should be taken when installing the LCD module to ensure pins are not bent or damaged. The LCD module is
vulnerable to electrostatic discharge (ESD); therefore appropriate ESD protection should be used.
The Digilent Pmod™ Compatible headers uses an SPI interface. Figure 5-1 below shows Digilent Pmod™
Compatible Header Pin Numbering(top view). Connection information for the Digilent Pmod™ Compatible
header is provided in Table 5-4 below.
Please note that the connector numbering adheres to the Digilent Pmod™ standard and is different from all
other connectors on the RSK designs. Details can be found in the Digilent Pmod™ Interface Specification
Revision: November 20, 2011.
Figure 5-1: Digilent Pmod™ Compatible Header Pin Numbering
Pin Circuit Net Name
1 PMOD1_PIN1
2 TXD8
3 RXD8
4 SCK8
5 GROUND
6 Board_3V3
Rev.
R20UT3027EG0100 1.00
Aug 24, 2015
Digilent Pmod™ Compatible Header (PMOD1) Connections
MCU
Port Pin
P33/PC4 17/48
PC7
PC6
PC5
-
-
Table 5-4: Pmod™1 Header Connections
Pin Circuit Net Name
7 IRQ6
45 8 IRQ7
46 9 PE3
47 10 PE4
- 11 GROUND
- 12 Board_3V3
5. User Circuitry
MCU
Port Pin
PE6 72
PE7 71
PE3 75
PE4 74
- -
- -
Page 22 of 53