Installation; Mechanical Installation - Lenze AC Tech MotionView OnBoard PositionServo PROFIBUS-DP Reference Manual

Communication module, communications interface
Table of Contents

Advertisement

3

Installation

3.1
Mechanical Installation
1.
Ensure that for reasons of safety, the AC supply, DC supply and +24V DC backup supply have been
disconnected before opening the bay cover plate.
2.
Remove the two COMM module screws that secure Option Bay 1. With the aid of a flat head screw
driver, gently pry up the Option Bay 1 cover plate and remove.
3.
Fit the 6 way pin header into the module before fitting the module into the drive.
4.
Install the PROFIBUS DP Module into the drive.
5.
Replace the two COMM module screws that secure Option Bay 1. Using a phillips-head screwdriver,
replace the GROUND screw as illustrated in Figure 2.
P94PFB01A
Installation
Figure 2: Installing the PROFIBUS-DP Communications Module
4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AC Tech MotionView OnBoard PositionServo PROFIBUS-DP and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents