Pentax DSI-200 Series User Manual page 88

Used to set the delay time for the inverter to change when the S-terminal status changes.
Currently only S1, S2, S3 with the delay time to set the function.
S1~S5 Terminal valid
mode selection 1
P4-38
Set range
Used to set the active status mode of the digital input terminal.
When the selection is active high, the corresponding S terminal is valid when connected to
the GND, and the switch is invalid.
When the selection is active low, the corresponding S terminal is inactive with GND and is
disabled.
P5 Group Output terminal
EV510 series inverter comes standard with two multi-function analog output terminals,
one multi-function digital output terminal, two multi-function relay output terminals,
one HDO terminal (can be selected as high-speed pulse output terminal, Open-circuit
switch output)
HDO Terminal output mode
P5-00
The HDO terminal is a programmable multiplex terminal that can be used as a high-speed
pulse output terminal or as a switch output terminal with open collector.
When the pulse is output, the maximum frequency of the output pulse is 100 kHz. Refer
to P5-06 for the related function.
P5-01
relay1 Output function selection（RO1A-
P5-02
The function of the multi-function output terminal is described below：
Set
Function
value
Non-output
0
1
The inverter is running
Error output(error
2
Bit
0：Active high
Ten
Hundred
Thousand
Million
selection
Set range
0：Pulse output（HDP） 1：Switch output（HDY）
HDY Output function selection（Open
collector output terminal）
RO1B-RO1C）
The output terminal has no function
Indicates that the inverter is running and has an
output frequency (which may be zero). At this time,
the ON signal is output.
When the inverter fails and the fault is stopped, the
ON signal is output.
Factory
value
S1 Terminal valid status setting
S2 Terminal valid status setting（0～1，see
S3 Terminal valid status setting（0～1，see above）
S4 Terminal valid status setting（0～1，see
above）
S5 Terminal valid status setting（0～1，see
above）
above）
Factory default
description
- 88 -
00000
1：active low
0
Factory
0
default
Factory
2
default