Pentax DSI-200 Series User Manual page 81

OFF ON
OFF ON
OFF ON
OFF ON
ON OFF
ON OFF
ON OFF
ON OFF
ON ON
ON ON
ON ON
ON ON
When the frequency source is selected as multi-step speed, the function code PC-00 ~ PC-
15 100.0%, corresponding to the maximum frequency P0-10.
Multi-segment instructions, in addition to the multi-speed function, can also be used as a
given source for PID or as a voltage source for VF separation control to meet the need to
switch between different set points.
Schedule 2 Acceleration / deceleration time selection terminal
function description
Terminal 2
OFF
OFF
ON
ON
S1~S7 Filter time
P4-10
Set the software filter time for S1 to S7 terminal status. If the use of occasions, input
terminals susceptible to interference caused by malfunction, this parameter can be increased
to enhance the anti-jamming capability. But the increase in the filter time will cause the S-
terminal response to slow.
The terminal controls the
operating mode
P4-11
Set range
This parameter defines four different ways of controlling the drive to run through an
Multi - step instructions 4
OFF OFF
Multi - step instructions 5
OFF ON
Multi - step instructions 6
ON OFF
Multi - step instructions 7
ON ON
Multi - step instructions 8
OFF OFF
Multi - step instructions 9
OFF ON
OFF Multi - step instructions 10
ON
Multi - step instructions 11
ON ON
OFF Multi - step instructions 12
OFF
Multi - step instructions 13
OFF ON
OFF Multi - step instructions 14
ON
Multi - step instructions 15
ON ON
Terminal 1
OFF
ON
OFF
ON
Set range
0 ： two wires 1
3：three wires 2
Acceleration or
deceleration time
selection
acceleration time 1
acceleration time 2
acceleration time 3
acceleration time 4
Factory
default
0.000s～1.000s
Factory
default
1 ： two wires 2
- 81 -
PC-04
PC-05
PC-06
PC-07
PC-08
PC-09
PC-10
PC-11
PC-12
PC-13
PC-14
PC-15
Corresponding
parameters
P0-17、P0-18
P8-03、P8-04
P8-05、P8-06
P8-07、P8-08
0.010s
0
2 ： three wires 1