Pentax DSI-200 Series User Manual page 26

UN key on the keyboard panel to start the self-learning operation of the motor parameters.
5. Function Parameters Table
PP-00 is set to a non-zero value, that is, the parameter protection password is set. In the
function parameter mode and the user changes the parameter mode, the parameter menu
must enter the password correctly and cancel the password.
The parameter menu in user-defined parameter mode is not password protected.
P group, a group is the basic function parameters, d group is the monitoring function
parameters. The symbols in the function table are described below:
"☆": indicates that the set value of the parameter is in the inverter is in shutdown, running
state, can be changed;
"★": indicates that the set value of this parameter cannot be changed when the inverter is
running;
"●": indicates that the value of the parameter is the actual detection record value, cannot be
changed;
"*": Indicates that the parameter is "factory parameter", only the manufacturer settings,
prohibit the user to operate;
- 26 -