Omron NX1P2 Series Hardware User Manual page 60

1 Introduction to NX-series Controllers
Support Software
You can use the following Support Software to set up, monitor, and debug an NX-series Controller.
• Sysmac Studio
The Sysmac Studio is the main Support Software that you use for an NX-series Controller. On it,
you can set up the Controller configurations, parameters, and programs, and you can debug and
simulate operation.
• Other Support Software
The following Support Software is also included in the Sysmac Studio Software Package Standard
Edition.
Configuration software
Sysmac Studio
Network Configurator
CX-Integrator
CX-Protocol
CX-Designer
*1. If the NJ/NX-series Controller is a target device, you may also use Sysmac Studio version 1.10 or higher. Use the Network
Configurator if a CS/CJ-series PLC operates as the originator device.
1-8
The Sysmac Studio is used for sequence control, motion control, and all other operations
except those described below.
The Network Configurator is used for tag data links on EtherNet/IP ports.
The CX-Integrator is used for remote I/O communications with a CJ-series DeviceNet Unit
or CJ-series CompoNet Master Unit.
The CX-Protocol is used for protocol macros with the CJ-series Serial Communications
Units.
The CX-Designer is used to create screens for NS-series PTs.
NX-series NX1P2 CPU Unit Hardware User's Manual (W578)
Application
*1