Omron NX1P2 Series Hardware User Manual page 223

Terminal Block Wiring
l Wire and Ferrule
Attach a ferrule to a wire, or use a solid wire.
Do not connect bare stranded wires directly to terminals.
The recommended solid wire specification and ferrule are given below.
Recommended solid wire
Wire type
Solid Wire
Recommended ferrule
Phoenix Contact
l Terminal Wiring
Release button
• To make the connection, insert the ferrule into the terminal hole on the terminal block. Insert the
ferrule until it is locked inside.
• To disconnect the wiring, press the release button in with a small flat-blade screwdriver and pull
the line out while the lock is released.
The screwdriver shown below is recommended for wiring.
Recommended screwdriver model
Model
SZS 0,4×2,5
*1
SZF 0-0,4×2,5
ESD 0.40×2.5
0,4×2,5×75 302
AEF.2,5×75
210-719
SDI 0.4×2.5×75
*1. You can purchase the SZF 0-0,4×2,5 screwdriver (manufactured by Phoenix Contact) from OMRON by specifying the
OMRON's model number (XW4Z-00B).
NX-series NX1P2 CPU Unit Hardware User's Manual (W578)
2 2
0.2 mm to 0.5 mm (AWG24 to AWG20)
Manufacturer
2-conductor shielded
twisted-pair cable
Manufacturer
Phoenix Contact
Wera
Wiha
Facom
Wago
Weidmuller
Wire size
Model Applicable wire
AI0,25-12
2
0.2 mm (AWG24)
5 Installation and Wiring
5-79
5