Windows 2000 Network; Introduction; Preliminary Steps; Quick Install Steps (Microsoft Tcp/Ip Protocol) - Xerox PHASER 5400 Quick Install Manual

Windows 2000 Network

Introduction

Your printer can be installed on a Windows 2000 network using one of
three methods:
Microsoft TCP/IP protocol


Xerox TCP/IP Port Monitor


AppleTalk protocol


The Preliminary Steps given below must be accomplished for all
printers regardless of the method that is being used. Then, the Quick
Install Steps detail the installation process corresponding to the
method selected.
The CentreWare DP program on your Printer Management Software
CD-ROM can also be used to monitor and configure the printer.

Preliminary steps

1. Print the Configuration Sheet. Details are in this document in
Appendix A: Print the Configuration Sheet. Retain this page for
reference.
2. Check the Configuration Sheet and verify that both the desired
protocol and connector are enabled.
3. Proceed to the Quick Install Steps for the installation method
selected.

Quick install steps (Microsoft TCP/IP protocol)

1. At the Desktop, right-mouse-click the My Network Places icon
and select Properties.
2. Right-mouse-click the Local Area Connection icon inside the
Network and Dial-up Connections window. Select Properties.
3. Select the General tab and verify that Internet Protocol (TCP/IP)
is loaded.
Quick Network Install Guide
13