Quick Install Steps (Xerox Tcp/Ip Port Monitor) - Xerox PHASER 5400 Quick Install Manual

23. If your print job did not print, see the Troubleshooting section for
your operating system in the Advanced Features and
Troubleshooting Manual to correct the problem.
Note
Printers connected to a Windows NT network with the
TCP/IP protocol enabled, can use a web browser to monitor
and configure your printer. Refer to the section in this
document entitled Internet Printer Services.
Note
For installing or managing multiple printers on a Windows
NT network with the TCP/IP protocol enabled, you can use
the Xerox CentreWare MC snap-in to Microsoft Management
Console. Refer to the Xerox CentreWare MC User Guide.

Quick install steps (Xerox TCP/IP Port Monitor)

1. Insert your printer's CD-ROM into your computer's CD-ROM
drive. A CD Navigator Utility should automatically start. If it does
not start, then:
a. Click Start and Run.
b. In the Run window, type: <CD drive>:\SETUP32.EXE.
2.
Select your desired language from the available list.
Printer driver installation
1.
Install the printer drivers for your printer. Within CD Navigator,
select Printer Drivers, and then select Install Xerox Phaser 5400
Laser Printer Drivers.
Note
The Xerox TCP/IP Port Monitor has not been installed yet. It
is necessary to temporarily install the printer drivers to an
alternate port. A local port, such as LPT1, is recommended.
Quick Network Install Guide
9