Windows Nt 4.X Network; Introduction; Preliminary Steps; Quick Install Steps (Microsoft Tcp/Ip Protocol) - Xerox PHASER 5400 Quick Install Manual

Windows NT 4.x Network

Introduction

Your printer can be installed on a Windows NT network using one of
three methods:
Microsoft TCP/IP protocol


Xerox TCP/IP Port Monitor


AppleTalk protocol


The Preliminary Steps given below must be accomplished for all
printers regardless of the method that is being used. Then, the Quick
Install Steps detail the installation process corresponding to the
method selected.
The CentreWare DP program on your Printer Management Software
CD-ROM can also be used to monitor and configure the printer.

Preliminary steps

1. Print the Configuration Sheet. Details are in this document in
Appendix A: Print the Configuration Sheet. Retain this page for
reference.
2. Check the Configuration Sheet and verify that both the desired
protocol and connector are enabled.
3. Proceed to the Quick Install Steps for the installation method
selected.

Quick install steps (Microsoft TCP/IP protocol)

1. At the Desktop, right-mouse-click the Network Neighborhood
icon and select Properties.
2. Click on the Protocols tab and verify that the TCP/IP protocol has
been loaded.
3. Select the Services tab and verify that Microsoft TCP/IP Printing
is loaded.
4. If this software is not present, install it using the documentation
provided by Microsoft, and then return to this document.
Quick Network Install Guide
7