Perform A Trace; Export The Trace File To Floppy - Xerox FREEFLOW 701P25032 System Manual

Hints and Tips

Perform a trace

Export the trace file to floppy

Utility
/opt/XRXnps/bin/setascii decomposer
/opt/XRXnps/bin/setfifomode
8- 8
To start the trace, perform the following:
1. Login as Administrator.
2. Select [System - Online Manager].
3. Select:
4. Channel Gateway - Enable
5. Input Device - Online
6. Input Control - Start
7. Submit a job from the host.
8. After the job is completely received by the Controller, select
Input Control - End.
9. Open a Terminal window.
10. Type cd /opt/XRXnps/XRXgrpset/bin and press <Enter>.
11. Type ./dspTrc > FileName.txt and press <Enter>.
12. Type ls -l and press <Enter> to see the new file and the file
size.
13. If the file size is greater than 1.44 MB, type compress
FileName.txt and press <Enter>. If the file size is less than
1.44 MB, go to "Export the trace file to floppy".
To export the trace file to a floppy, perform the following:
1. Insert a blank, formatted floppy into the floppy drive.
2. Type volrmmount -i and press <Enter>.
3. If you used the "compress" command above, type cp
FileName.txt.Z /floppy/floppy0 and press <Enter>. If you did
not use the "compress" command above, type cp
FileName.txt /floppy/floppy0 and press <Enter>.
4. Type eject and press <Enter>.
Change Description
Forced ASCII files through
designated decomposer (that is,
ASCII through PCL). Implemented
in queue manager in 2.1
Enables FIFO job reception mode
in front end of system.
Focus
Black and
white
Both
System Guide