Additional Features Supported In Snmp - Xerox FREEFLOW 701P25032 System Manual

Gateway and Network Configuration
SNMP gateway configuration

Additional features supported in SNMP

Ability to SET Attributes
1- 6
SNMP displays the status of network devices. Using the SNMP
tab in the Xerox FreeFlow Print Server Gateways, the
administrator can select among a number of features and settings
for SNMP.
NOTE: SNMP requires a standard license. The System
Administrator must enable SNMP in License Manager.
Xerox recommends the following third–party SNMP software
managers:
• IBM Network Printer Manager (XP)
• TNG Unicenter (XP)
• HP OpenView (UNIX, XP)
• Xerox CentreWare (UNIX, XP)
NOTE: The SNMP manager (for example, HP OpenView) may
have a number of requests into the Xerox FreeFlow Print Server
for information. The requested information may not be among the
supported data sets on the Print Server. When this occurs, the
SNMP client/manager displays "no value...etc".
NOTE: You can have more than one SNMP manager running at
the same time.
SNMP support for the following features are product dependent:
• The ability to 'SET' attributes.
• The ability to localize text and units of measure.
• The ability to support a number of MIBs related to finishing and
printing.
• The ability to perform automatic meter reading.
The following table specifies which Xerox products have these
SNMP supported features:
Table 1-1
SNMP Supported Features by Product
DT 61XX
Feature and DP
1xx
Y
EPS 1XX iGen
Y N
Nuvera
1xx
Y
System Guide