Adjusting The Position Of Media Sensor - CAB e4 Series Operator's Manual

PRODUCT MARKING AND BARCODE IDENTIFICATION

Adjusting the Position of Media Sensor

1. Lift the top cover.
2. Push the Release Lever to release the Printhead Module.
3. Lift the Printhead Module to expose the media sensor cover. (Figure 7-1).
4. Remove the media sensor cover and slide the media sensor to the correct position (refer to Figure
7-3, Figure 7-4 and Figure 7-5).
5. Replace the media sensor cover.
Figure 7-1
cab Produkttechnik GmbH & Co KG
Media sensor cover
17
17