Loading The Media - CAB e4 Series Operator's Manual

PRODUCT MARKING AND BARCODE IDENTIFICATION

Loading the Media

Standard Mode
1. Lift the top cover to expose the media compartment (Figure 6-1).
2. Load a roll of media (labels facing up) on the Media Spindle, then
slide two Media Roll Guides with their smooth sides toward the media
onto the Media Spindle from each end until snug to the media. If you
are placing a roll of media with 3" ID core, please slide the two Core
Adapters onto the Media Spindle first.
3. Insert them into the printer (Figure 6-2).
4. Corresponding to the scale on the Media Spindle, position the media
roll right in the middle of the Spindle.
5. Release and lift the Printhead Module.
6. Route the media as shown in Figure 6-3.
7. Slide the Media Guide to the edge of the media.
8. Close the Printhead Module and press down until it locks into place
(Figure 6-4).
9. Close the cover and press the 'Feed' button to feed the media and
ensure proper tracking. If the printer does not correctly sense the top
of each label it may be necessary to perform the Calibration Procedure
shown in the Operation Basics section.
16
cab Produkttechnik GmbH & Co KG
16