Buttons; System Mode - CAB e4 Series Operator's Manual

PRODUCT MARKING AND BARCODE IDENTIFICATION

Buttons

Three buttons perform different functions based on the mode the printer is in. The printer operates in one
of the following modes:
Normal Mode:

System Mode:

Mode
FEED
PAUSE
CANCEL
System Mode
In System Mode the printer's buttons allow the printer to perform Reset, Media Sensor Calibration and
Self-testing. The printer cannot receive commands from the host when in System Mode.
- Entering: Press and hold CANCEL button for 4 seconds, the three blinking lamps indicate the printer
is in System Mode.
- Exiting: The printer will exit System Mode automatically if no further operations are requested in 4
seconds after entering System Mode.
Reset – Reset the Printer to Factory Default Settings
Following the steps listed below allows you to reset the printer to factory default settings.
1. After entering System Mode, press CANCEL button.
2. The three indicators stop blinking and remain lit. The printer is back to a normal state.
cab Produkttechnik GmbH & Co KG
Normal printer functions (i.e. Pause, Feed, and Cancel). See the table below.
Allows the printer to perform Reset, Media Sensor Calibration and Self-testing.
See the following table at section 'System Mode'.
Normal Mode
Feeds one label
-Press once to pause
current print job
-Press a second time to
resume work c
-Cancels current batch
of labels
-Forces the printer to
continue working
after an error has
been solved
System Mode
Media Sensor Calibration
Self-test:
the printer performs a
self-test and prints out a
onfiguration report
Reset:
reset the printer to
Factory Default Settings
21
21