Loading The Ribbon - CAB e4 Series Operator's Manual

PRODUCT MARKING AND BARCODE IDENTIFICATION

Loading the Ribbon

Caution: (1)
(2)
(3)
1. Lift the top cover (Figure 5-1).
2. Push the Release Lever to release the Printhead Module.
3. Lift the Printhead Module to expose the ribbon supply holder (Figure 5-2).
4. Unwrap the ribbon roll pack and separate the ribbon roll and the empty core (Figure 5-3).
5. Slide a roll of Ribbon onto one of the Ribbon Spindles and an Empty Core onto the other spindle
(Figure 5-3).
6. Load the Ribbon Spindle into the printer and route the ribbon through the Printhead Module as shown
in Figure 5-4.
7. Wrap the end of the ribbon around the empty core (Figure5-5).
8. Load the empty core into the Ribbon rewinder (Figure5-6).
9. Turn the guide wheel on the left of the empty core to take up the loose ribbon and tighten the ribbon.
10. Close the Printhead Module and press down until it locks into place.
12
Make sure the inked side of your ribbon faces outwards.
Always make sure the inked side of the ribbon faces
the media and NOT the printhead.
The maximum width of the ribbon is 110mm. When
using a ribbon roll with a width less than 110m,
please place the ribbon roll right in the middle of the
Ribbon Spindle corresponding to the symmetry symbol (-->|<--).
This section isnot applicable to direct thermal printing.
cab Produkttechnik GmbH & Co KG
12