Correct Measuring Posture; Wrapping The Cuff - Nissei DS-1011 Instruction Manual

Press "SET" KEY until "2011" starts fl ashing.
Clock is set in the order of year, month, day, hour and minute.
The fl ashing number increases with
you keep your fi nger on the key. Pressing "SET" will fi x the number and the next article will fl ash.
Pressing "START/STOP" will terminate the setting.
IMPORTANT! If the date and time have been set, current time will be shown on the display when the
device is turned off .

CORRECT MEASURING POSTURE

Sit down at the table with your back
supported and feet fl at on the fl oor so that
during the blood pressure measurement your
forearm and hand are on its surface. Make
sure that the place where the cuff is put on
the upper arm is about the same level as the
heart and the forearm and hand freely lie on
the table and does not move(fi g.4).
Pressure measurement while lying. Place the
cuff at heart level, using a case or a folded
towel (fi g.6).
The results of measurements can vary slightly depending on the posture during the measurement. If the
cuff is below (above) in relation to the heart, the measurements will be overstated (understated).

WRAPPING THE CUFF

Fig.7
Fig.8
and decreases with
1 Put the cuff on your left arm with AIR HOSE positioned toward your arm.
(fi g.7). You may use your right upper arm for measurement (the results of
measurements can slightly).
2 Attach the cuff with hook and loop fastener with the lower edge of the
cuff approximately 2 to 3 cm above the inner elbow. Adjust the position of
the cuff so that AIR HOSE is over the inner part of your arm over the brachial
artery (fi g.8).
. The number will be fast-forwarded if
Fig.4 Fig.5
57
Fig.6