Loading Roll Media Onto The Unwinder - Xerox 8254E User Manual

2.4 Loading Roll Media onto the Unwinder

The following section describes how to load roll media on the Unwinder.
Media core size 3 inch：Maximum media width 1625mm, Minimum media width 1000mm,
media outside diameter less than 250mm, weight less than 100kg.
Roll media must be loaded in the center of the of printer.
1. Set the Unwinder / Winder Power Switch to ON.
2. Set the Automatic Operation Switch to OFF.
Figure 12. Set Unwinder Automatic Operation Switch to OFF
3. Loosen the Left and Right Unwinder Spindle Locking Handles and move the spindles so that the
distance between the left and right spindles is wider than the roll media width that will loaded.
100kg Unwinder / Winder User Guide
4
1
Figure 13. Install Roll Media
No.
1 Left Unwinder Spindle
2 Right Unwinder Spindle
3 Roll Media
4 Unwinder Spindle Locking Handles
2 Unwinder / Winder Operation
2
3
Part name
4
11