Circutor Wibeee Max Instruction Manual page 19

Wibeee Max
2�- Connecting��� state
In this state, the Wibeee Max is managing the connection with the router/access point.
This state should last for 40 seconds, when there is good Wi-Fi coverage. In places where there
is weak Wi-Fi coverage, it may take longer.
If it takes longer than 2 minutes, it is recommended to return to the initial state, check the Wi-Fi
coverage and re-start the process.
If it is unable to connect to the Wi-Fi, the device retries 5 times. If the lack of connection per-
sists, it goes into Configuration mode (so that the configuration can be changed without open-
ing the panel) for 5 minutes; it then tries to reconnect again and, until it manages to reconnect,
it remains in this alternating mode. (5 minutes in the Configuration state and 1 attempt to
connect).
3�- Connecting state
In this state, the device has connected to the Wi-Fi network and is waiting to complete the first
successful transfer of data.
When it first manages to successfully send data, it will enter the "Connected and sending OK"
state.
If the device is not able to successfully send the first set of data, it will retry 3 times. If it does not
manage to send it, the Wi-Fi connection is restarted and it retries sending the package 3 times.
It remains in this state until the first data is successfully sent.
4�- Connected and sending OK state
When the device is configured and connected to the network in the user's infrastructure, it
automatically starts sending data on the installation's power consumption to the server (every
minute).
It also allows you to access instant measurements by making requests to its internal XML and
Modbus servers.
Instruction Manual
Blue LED → Off
Red LED → Slow blinking light (1s)
Blue LED → Fast blinking light (<1s)
Red LED → Slow blinking light (1s)
Blue LED → Steady light.
Red LED → Slow blinking light (1s)
19