Table of Contents
Advertisement
P C L M e n u
Figure 3.10 PCL Menu options showing factory settings (continued)
Option
Page Protection
Jam Recovery
Note: The default for Jam
Recovery is On for
firmware release 4.0. The
default is Off (as shown at
right) for releases > 4.0. To
determine the firmware
release of your printer,
print a Configuration
Sheet.
3-26
4 5 0 5 / 4 5 0 5 p s o r 4 5 1 0 / 4 5 1 0 p s U s e r ' s G u i d e
Setting
Off*
A4 (210x297)
Legal (8.5x14)
Letter (8.5x11)
See Figure 2.3 (page 2-6)
for more paper
dimensions.
Off*
On
Description
Use to reserve memory for a full page of the selected
paper size.
When Off, memory is not reserved for an entire page.
It then becomes possible for a page to be too complex
to compose. The result is a
error message and the page may be printed on more
than one sheet of paper.
When set to a paper size, each page is composed into
reserved memory before the paper starts to move
through the printer. The printer may slow down
slightly with Page Protection; however, you will be
assured of printing a complex page on one sheet of
paper.
Page Protection can be overridden by software
when the Xerox printer driver is installed.
See "Printer Settings that Affect Memory" (page 3-67)
for further information.
Determines how the printer recovers from a paper
jam. It is set independently for PCL and PostScript.
When On, the printer reprints any pages in the printer
at the time of the jam, after the jam has been cleared.
The printer does this by using a portion of memory to
store data. This setting can reduce printer speed with
minimum memory installed. Printer speed can be
increased by installing additional memory and/or
using the default setting of Off.
When Off, some pages may be lost after the jam has
been cleared. The print job must be resent, specifying
those pages that did not print as a result of the paper
jam.
See "Printer Settings that Affect Memory" (page 3-67)
for further information.
Page Too Complex
Advertisement
Table of Contents
