Table of Contents
Advertisement
S y s t e m M e n u
System Menu
Options
Figure 3.20 System Menu options showing factory settings
Option
Hex Dump
Chime
System Messages
Note: This option is
available for firmware
release 4.0 only. To
determine the firmware
release of your printer,
print a Configuration
Sheet.
3-58
4 5 0 5 / 4 5 0 5 p s o r 4 5 1 0 / 4 5 1 0 p s U s e r ' s G u i d e
In Figure 3.20, System Menu options and their settings are
described. Factory settings are boldfaced, followed by an
asterisk (*). See "Setting a Menu Option" (page 3-10) for the
steps to find and change a setting, or refer to the Document
Services for Printing Guide to use the RUI to change settings.
Setting
Off*
On
Off
Once*
Continuous
Off
On*
Description
Print output as hexadecimal codes instead of normal
print data.
When Off, data is printed normally.
When On, Hex Dump is used for error checking and
error analysis.
When Hex Dump is On, the Control Panel
menus are not available.
Note
Audible chime signal for attention.
When Once, the printer sounds one audible chime
when needing attention.
When Continuous, the printer sounds frequent
audible chimes when needing attention.
When Off, no chime sound is produced.
Display of system error messages.
When On, system error messages are displayed.
When Off, no system messages are displayed.
Advertisement
Table of Contents
