Making A Network Host Connection - Xerox -05W User Manual

Getting Started
Note: The options in this dialog box are described in the Serial
The status bar along the bottom of the TeemTalk window displays two LEDs. The first
LED indicates whether or not you are connected to the host. It will show red when
not connected and green when you are connected. The second LED indicates
whether or not data is being sent to or from the host. It will show dull green when
there is no activity, red when data is being sent to the host, and bright green when
data is being received from the host.

Making A Network Host Connection

To connect to a network host, select the protocol required in the Type list box:
TeemTalk for Windows 95 and NT:
TCP/IP
NetBIOS
LAT
TeemTalk for Windows 3.1x:
LAT
FTP PC/TCP
Sun PC/NFS
LAN W/Place
NetManage
PathWay
CTERM
Note: Refer to the Network Connection chapter in the Networking
2-4
Settings section in the Setup Menus chapter and only apply
when the connection type is set to Serial.
CTERM
MultiLan
Microsoft SNA
NetBIOS
OSLAN
TELAPI
BAPI
Interrupt 14
INT6B / NASI
LanManager
Guide for a description of each protocol supported and for
any additional configuration required prior to making a
connection.
WinSock 2
ISDN
TeemTalk-OSI (option)
B and W. TCP
WinSock
Ext. NCSI
Eicon X25
IPX/SPX
NetWare for LAT
TeemTalk-OSI
INFOConnect
ISDN
DOSLANTI
MultiLan