Host Command Summary
This appendix lists the host and Tek Primary Setup commands that are
valid in each terminal emulation mode. TeemTalk-specific commands
are listed at the back.
The following conventions are used in this command list:
Spaces in a command are for clarity only and are not to be entered as part of the
command. A space character that is part of the command will be shown as SP.
An asterisk (*) in a command indicates the location of one or more parameters
except otherwise indicated next to the command.
VT52 Mode
CHARACTER SET SELECTION
Invoke G0 character set
Invoke G1 character set
Select G0 character set
Select Line Drawing character set
CURSOR
Direct cursor addressing (1 to 96 = SP to DEL)
Insert FF character & advance cursor
Line feed
Move cursor down one line
Move cursor down one line
Move cursor home
Move cursor one column left
Move cursor one column left
Move cursor one column right
Move cursor to left margin of current line
Move cursor to next tab stop
Move cursor up one line
Reverse line feed
Host Command Summary
HOST
PRIMARY SETUP
SI
SO
ESC G
ESC F
HOST
PRIMARY SETUP
ESC Y *line *column
FF
LF
ESC B
VT
ESC H
BS
ESC D
ESC C
CR
HT
ESC A
ESC I
E
E-1