Table of Contents
Advertisement
File Transfer
YMODEM Batch
YMODEM Batch is similar to XMODEM-1K, but enables several files to be
transferred. It checks for errors using a cycling redundancy check only.
ZMODEM
ZMODEM is an advanced development of YMODEM which enables much faster
multiple file transfer with enhanced error detection and aborted transfer resumption.
The zmodemStartup initialization command or -zm command line option can be
used to make TeemTalk check incoming data for a remote ZMODEM startup sequence
then automatically start a file transfer.
Note: XMODEM, YMODEM Batch and ZMODEM require a
ASCII
ASCII file transfer enables characters to be sent with no handshaking (unless XON/
XOFF is enabled) or error checking.
ICL FTF
The ICL FTF protocol supported by TeemTalk for Windows 3.1x can be used in any
terminal emulation mode. It requires the DOSLANTI TSR to be loaded, but it is not
necessary for the user interface providing you do not attempt to initiate a transfer.
Refer to the ICL FTF File Transfer chapter for details on how to use it.
8-2
communication setting of 8 data bits, 1 stop bit and no
parity. These settings will automatically be used for the
transfer, after which the original settings will be reasserted.
Advertisement
Table of Contents
