Preliminary Procedure; Oil Change; Wheel Reducer - Haulotte H28TJ+ Maintenance Book

Control-Oil change

Wheel reducer

15 mn
Control-Oil change
Wheel reducer
1 - You will need
• Standard tool kit
• Protective goggles
• Gloves
• Oil collection pan

2 - Preliminary procedure

1. Place the machine in maintenance configuration.
configuration
3 - Control
1. Turn the wheel to obtain the following configuration :
2. Plug ( 1 ) is on a horizontal line.
3. Plug ( 2 ) is on a vertical line.
4. Loosen and remove plug ( 1 ).
5. Check the oil level.
6. Top up the oil level to the hole, if necessary.
7. Refit and tighten plug ( 1 ).

4 - Oil change

1. Turn the wheel until plug ( 2 ) is directed downwards.
2. Loosen and remove plugs ( 1 ) and ( 2 ).
3. Let the oil drain out.
4. Refit and tighten plug ( 2 ).
5. Turn the wheel again to the level control position.
6. Fill the wheel reducer with oil up to hole ( 1 )
7. Refit and tighten plug ( 1 ).
Use an oil collection pan to avoid polluting the environment.
5 - Additional operation
1. Place the machine in its operating configuration.
2420333140 E06.13
• Place barriers around the perimeter of the
work area
3.3.1-Placing the machine in maintenance
1
3.3.2-Placing in operating configuration
E002
2
1
2
97
EN