Control-Filling-up-Battery charge
Battery
10 min
Control-Filling-up-Battery charge
Battery
1 - You will need
• Standard tool kit
• Protective goggles
• Gloves
2 - Preliminary procedure
The battery manufacturer's safety instructions must be followed.
1.
Place the machine in maintenance configuration.
configuration
3 - Control
Loosen the caps located on the top of the battery.
The level of electrolyte in the battery must be approx. 0,01 m(0 ft39 in) above the plates.
4 - Filling-up
Loosen the caps located on the top of the battery.
If the level of electrolyte is below the level of the plates : .
1.
Top up with distilled water.
2.
Refit and tighten the battery caps.
2420333140
E06.13
• Place barriers around the perimeter of the
work area
3.3.1-Placing the machine in maintenance
E018
133
EN