To Restore Settings Or Clone Settings To Another Machine - Xerox WorkCentre 7335 System Administrator Manual

To Restore Settings or Clone Settings to another Machine

Note: This procedure will cause the machine to reboot and will be unavailable over the network for
several minutes.
Note: All machines must have the same version of software for the .dat file to be accepted
1. Open your web browser and enter the TCP/IP address of the machine that you wish to restore or clone
the settings to. Press Enter.
2. Click the Properties tab.
3. Click the General Setup folder, then Cloning.
4. In the Cloning area, in the Install Clone File box:
a. Click Browse and move through your file system to the .dat file.
b. Click Open.
c. Click Install.
5. If prompted, enter the current administrator User name and password. The default is 11111 and x-
admin.
Note: The machine will be unavailable over the network for several minutes.
6. Once rebooted a Configuration Report should automatically print, if enabled. If the Configuration
Report does not automatically print, manually print the list by referring to the instructions in the
Configuration Report topic in the Network Connectivity section of this guide. Looking at the
Configuration Report, verify that some or all of your settings have been cloned to the new machine.
Also, note that it may be necessary for you to use your web browser to view the Xerox Standard
Accounting set up of Users and Groups on the new machine.
224