Enabling Ports And Setting Tcp/Ip - Xerox WorkCentre 7335 System Administrator Manual

Enabling Ports and Setting TCP/IP

In order to use the job flow service, you must enable the SOAP port, the SNMP port, the Internet Service
(HTTP) port, and set IP addresses. The procedure for setting the machine is as follows.
Note: The configuration can also be performed using CentreWare Internet Services.
For information on how to use CentreWare Internet Services, refer to the Internet Services section of
this guide.
1. Display the System Administrator Menu screen.
a. Press the Log In/Out button.
b. Enter the user ID with the numeric keypad, or the keyboard displayed on screen, and select Enter.
Note: The default user ID is "11111". When using the Authentication feature, a password is required.
The default password is "x-admin".
c. Press the Machine Status button on the Control Panel, then touch the Tools tab.
2. Enable the SOAP port.
a. Select Connectivity & Network Setup.
b. Select Port Settings.
c. Select SOAP and then select Change Settings.
d. Select Port Status and then select Change Settings.
e. Select Enabled then select Save.
f. Select Close until the Port Settings screen is displayed.
145