Storing The Panel Shipping Restraints - HP StorageWorks ESL E Series Unpacking And Installation Manual

1
1
Panel restraint storage location (left side shown)
Figure 23 Storing the panel shipping restraints
17. Using the power cables from the accessory kit, connect the library to a grounded
power source, using the following procedure.
a.
Connect the cables to the library's main power source.
b.
Route the cables through the cable access hole at the bottom of the cabinet.
c.
Connect the cables to a grounded power source.
NOTE:
Do not power on the library. The two breaker switches on the power
distribution unit should remain in the off position (to the left) until the library
is fully installed.
HP StorageWorks ESL E-Series Tape Library unpacking and installation guide
39