Resuming From Power Saving Mode - Fujitsu FI-5950 Operator's Manual

2.14 Resuming from Power Saving Mode

Power saving mode saves the power consumption of the scanner while the power is turned on. When the
scanner is left without operation for 15 minutes or more (factory initial setting), it automatically enters the
power saving mode.
When the scanner entered the power saving state, the LCD indication of Operation panel becomes off and
the green LED lamps for Power button and Paper Thickness keeps lighting.
If you want to resume the scanner from the power saving mode, take any of these actions below.
Set documents on the hopper.
•
Press any button on the Operator panel (except the Power button*).
•
* If you press the power button for two seconds or longer, the power is turned off.
Execute any command from the scanner driver screen in the PC.
•
Also, the scanner can be set to turn itself off automatically when it is turned on and left unused for a certain
period of time.
You can save the power consumption by having the scanner turn off automatically.
To enable this setting, select the [Power off after a certain period of time] check box in [Device Setting] of
the Software Operation Panel. For details, refer to
To turn the scanner back on when it is automatically turned off, press the power button on the scanner.
For details, refer to "2.1 Turning the Scanner ON /OFF" on page
ATTENTION
HINT
"8.2 Power saving setting" on page
• Depending on the application you are using, the scanner may not be
turned off automatically even when the [Power off after a certain period
of time] check box is selected.
• If the scanner turns itself off automatically while you are using an image
scanning application, close the application first, then turn the scanner
back on.
The waiting time for entering the power saving mode can be set in a range
from 15 to 55 minutes in steps of 5 minutes. To set the power saving mode,
refer to "8.2 Power saving setting" on page

2.14 Resuming from Power Saving Mode

142.
8.
142.
2
41