Table of Contents
Advertisement
1 Safety information
The device is built according to the relevant standards and directives as well as to the applicable safety
regulations. Nevertheless, improper use, incorrect installation or configuration can result is erroneous
measurements. Depending on the plant, this may cause unwanted control actions (e. g. overmetering)
in the plant. Personal injury and property damage must be prevent through appropriate safety measures
and safety devices provided by the customer.
To avoid danger, only use the device:
•
for the intended use
•
when in good order and condition
•
In compliance with these instructions
WARNING!
Error during installation, mounting, or configuration of JUMO sensors with digiLine electronics
can disrupt proper execution of the downstream process or cause damage.
For this reason, it is always necessary to provide safety devices that are independent of the device
and to allow settings to be made only by technical personnel.
CAUTION!
JUMO sensors with digiLine electronics must be calibrated correctly to prevent measurement er-
rors.
1.3
Qualification of personnel
This manual contains the necessary information for the intended use of the device described therein.
It is meant for technically qualified individuals who have been specially trained or have the appropriate
know-how in the field of automation technology (measurement and control instrumentation).
Understanding and technically correct observance of the safety instructions and warnings contained in
this manual are prerequisites for safe mounting, installation, and startup as well as safety during opera-
tion of the described device. Only qualified individuals have the required technical knowledge to interpret
and put into practice the safety instructions and warnings used in this manual in any given situation.
8
Advertisement
Table of Contents
