Table of Contents
Advertisement
12 Configuration
Configuration item
Sig. sec. value
Measuring ranges 1 to 4
Configuration item
Bargraph start
Bargraph end
Decimal place
64
Selection/setting op-
tion
No signal
Temperature input
Compensation temp.
Uncomp. conductivity
Compens. Conductivity
Selection/setting op-
tion
XXXX
XXX.x
XX.xx
X.xxx
Explanation
Signal source for the secondary value display
In the measuring mode, the secondary value is shown on the
display as an additional value accompanying the main value
(smaller display below the main value).
The appearance of the display can be set in the display type
(higher up in this table).
Explanation
Measured value of the main value at the start of the bargraph
display
Measured value of the main value at the end of the bargraph
display
Number of desired decimal places
The number of decimal places can be set from 0 to 3.
Advertisement
Table of Contents
